Specification Sheet

Channel Framed Mirror/Shelf Combination 18" W x 24" H (46 x 61cm)

Features:

• One-piece, 1/2" x 1/2" x 3/8" (13 x 13 x 9.5mm) channel-frame.
• Type 430 stainless steel with bright-polished finish.
• Mitered corners.
• Frame screw permits easy replacement of glass.
• No. 1 quality, 1/4" (6mm) glass mirror; warranted against silver spoilage for 15 years.
• Galvanized steel back.
• Secured to concealed wall hanger with theft-resistant mounting.
• Type 304 satin-finish stainless steel shelf.
• Shelf projects 4" (100mm) with 3/8" (10mm) return on front and sides; front return edge hemmed for rigidity and safety. 

Materials:

• Frame — Type 430 stainless steel, 1/2" x 1/2" x 3/8" (13 x 13 x 9.5mm) channel 1/4" (6mm) return at rear. For Snap Locking Design; 1/2" x 1/2" x 1/2" (13 x 13 x 13mm) channel for "2S" Design Tab, with bright polished finish. One-piece frame with 90 degree mitered corners. Galvanized steel back has integral horizontal hanging brackets near the top for hanging the mirror and near the bottom to prevent the bottom of the mirror from pulling away from the wall. Locking devices secure mirror to concealed wall hanger.
• Shelf — 18-8, type 304, 18-gauge (1.2mm) stainless steel with satin finish. Return edge on front, hemmed for additional strength and safety. Once mounted properly, mirror shelf meets accessible design by protruding 4" (102mm) from the wall.
• Mirror — No. 1 quality, 1/4" (6mm) select float glass: selected for silvering, electrolytically copper-plated by the galvanic process, and guaranteed for 15 years against silver spoilage.
• Back is protected by full-size, shock-absorbing, water-resistant, nonabrasive, polyethylene padding.
• Concealed Wall Hanger — Heavy gauge steel construction. Incorporates upper and lower support members, which engage backplate louvers to keep mirror against wall for Snap-locking design. Double-sided tape secures mirror to concealed wall hanger for "2S" Design Tab design.

Installation:

• Mount wall hanger on wall with screws (not furnished) at points indicated by an S. For plaster or dry wall construction,provide backing to comply with local building codes, then secure wall hanger with screws (not furnished).
• When providing a concealed backing, allow backing to cover minimum range of mounting hole locations shown on drawing.
• For other wall surfaces, provide fiber plugs or expansion shields for use with screws (not furnished), or provide 1/8" (3mm) toggle bolts or expansion bolts. Hang mirror on wall hanger with all four backplate louvers engaged behind horizontal wall hanger members. To do this, mirror must be centered in front of the wall hanger horizontally, pressed flat against the wall approximately 1" (25mm) above final position and then lowered into final position. Place shelf below mirror and install with wall screws (not furnished) at points indicated by S.